Frequent cycling, a yellow burner flame or weak airflow can all signal that your furnace needs repair. Learn the early signs and when to call.

If your furnace broke down in the middle of winter, it would be obvious that it needed repairs. Ideally, though, you want to fix a problem before it reaches that point.
By learning the early symptoms of a heating issue, you can schedule repairs promptly and avoid more serious problems.
One symptom that can escape your attention is a heating system that seems to run all the time. The soft rush of air may be the only sign that your furnace is cycling, and if you are used to that sound, you may not notice a change.
If your system seems to be running more often than usual, schedule an inspection. You may just need your thermostat recalibrated, but there could be another reason your furnace is not keeping up with your home's heating needs.
Gas furnaces should burn with a steady, mostly blue flame. A flame that is yellow, orange or flickering can mean the burners are not burning cleanly, which can produce more carbon monoxide.
If you notice a change in your furnace's flame color, turn the system off and request HVAC service right away. Every home with gas appliances should have working carbon monoxide detectors, and if a detector sounds, leave the home and call your gas utility or 911.
You might also notice that less air is coming from your vents than before. Anytime your vents are not putting out as much air, it is a good idea to call for heating repair.
A technician can tell you whether the cause is your ductwork, a failing blower motor or a clogged filter, and then correct the problem to restore efficient heating.
Gibson Home Services provides heating maintenance, repair and replacement for homes in Burlington County. We perform routine tune-ups and inspections as well as gas furnace repairs and new system installations.
If your heating system needs attention, call (856) 220-4158 or request service online.
Latest articles
Discover more articles
Diagnosing a Low Voltage Short at the Furnace Control Board
When your heating system fails to start this fall, a blown 3-amp fuse is often the culprit. Learn why professionals must trace the entire thermostat wire instead of just swapping the fuse.
Where to Place Carbon Monoxide Detectors Relative to Your Gas Furnace Location
Mounting a safety alarm directly next to your heating system often triggers frustrating false alarms. See why the 15-foot rule provides genuine early warnings without the nuisance.
The Impact of Hard Water on Whole-Home Humidifiers in Burlington County
Mineral scale from local water supplies can quietly choke your heating system's efficiency. Replacing your humidifier water panel before winter hits is critical to preventing sudden comfort loss.